Free on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Before
After
Before
After
Before
AfterGate Repair in Colleyville, TX
Gate access control in Colleyville means keypads, intercoms, and card readers wired into wrought-iron driveway gates on estate-sized lots. The clay soil under this city moves with every wet spring and dry summer, so the electronics get misaligned, wiring gets stressed, and posts shift enough to trip safety sensors. We fix the access system and the gate it controls. Call (817) 674-6552 when a keypad quits or a remote stops triggering the opener.
Why Colleyville Homes Are Different
Colleyville sits on Blackland Prairie clay that expands when wet and contracts hard in summer drought. That shrink-swell cycle heaves gate posts, throws swing gates out of plumb, and cracks concrete footings on a seasonal loop. Most driveways here hold a heavy ornamental iron gate, often 16 to 20 feet wide, hung on custom posts and driven by a commercial-grade operator. The gate was built for the house, not bought off a shelf, which means every repair has to account for the weight, the soil, and how the original installer set the limits. We work on those systems daily and know what the clay does to them by late August.
Our Main Colleyville Services
Two calls dominate our Colleyville schedule: access systems that no longer respond and gate hardware that has shifted or failed. Below are the three full-service pages for this city.
Gate Repair in Colleyville
When a Colleyville gate stops swinging or sliding correctly, the cause is usually post movement from clay soil, a failed hinge, or a limit switch knocked out of calibration. We inspect the full travel path, photograph what we find, and write the price before any work starts. Full details live on our Gate Repair in Colleyville page.
Gate Installation in Colleyville
New Colleyville gates are custom-fabricated to match the house and set on footings deep enough to survive the clay. We measure the opening, spec the correct operator for the gate’s weight, and document every setting. See the full scope on our Gate Installation in Colleyville page.
Gate Motor & Opener in Colleyville
Operators on Colleyville estate gates run harder in summer heat, and we service all nine major brands without steering you toward a replacement. If the motor still has life, we fix it and leave the settings documented. Full detail on the Gate Motor & Opener in Colleyville page.
What happens when you call
- 1
A real person answersNo phone trees - you reach a local pro.
- 2
You get an upfront price rangeHonest numbers before anyone is dispatched.
- 3
A background-checked tech heads outLicensed & insured, dispatched right away.
- 4
You approve before work beginsNothing starts until you say go.
Before
AfterGate Access Control in Colleyville
Gate access control in Colleyville means the keypad, phone entry, intercom, or card reader that tells a heavy estate gate to open. The weather here punishes exposed electronics: 100-degree summers bake circuit boards, and clay soil movement flexes the wiring runs between the house and the gate. When a Colleyville homeowner says the gate won’t open, the problem is often the access device, not the motor. We diagnose the full path from the keypad to the operator and fix what actually failed. Our Gate Access Control team carries parts for most major brands on the truck.
Keypad Entry
Signs you need it
The keypad lights but won’t trigger the gate, or it works only when pressed a certain way.
What it costs in Colleyville
Keypad replacement or repair in Colleyville typically runs $180 to $480 depending on the type and whether the wiring is intact.
How we do it
We test voltage at the keypad, check the wiring run for breaks, replace the unit if needed, and reprogram every code while you watch.
Video Intercom
Signs you need it
The video feed is blank, the call button won’t ring the house, or the unlock function stopped working.
What it costs in Colleyville
Video intercom work in Colleyville typically runs $400 to $1,200 depending on the wire condition and whether we replace the monitor, camera, or both.
How we do it
We identify where the signal drops, test the wiring run, and replace only the failed component, then photograph the final configuration.
What Gate Access Control Costs in Colleyville
| Item | Typical range in Colleyville |
|---|---|
| Keypad replacement or repair | $180 - $480 |
| Video intercom repair | $400 - $1,200 |
| Phone entry or card reader programming | $150 - $350 |
Can you come today for a Colleyville access control repair?
Yes. A live person answers 24/7, and we schedule access control calls in Colleyville same day in most cases. Call (817) 674-6552 and we’ll give you a written price before starting.
Do you replace only the keypad or the whole system?
We replace only the failed component. If the keypad is dead but the operator and wiring are fine, you get a new keypad and a documented record, not a system upsell.
Gate Parts & Welding in Colleyville
Gate parts and welding in Colleyville usually means repairing heavy ornamental iron that has shifted on clay soil. The shrink-swell cycle cracks welds, pulls hinges out of alignment, and bends rails on slide gates. We repair the steel and reset the gate to travel correctly, leaving a photo record of every weld and adjustment. Our Gate Parts & Welding work is priced in writing before the torch comes out.
Hinge Replacement
Signs you need it
The gate sags, scrapes the ground on one side, or the hinge pin shows visible wear or play.
What it costs in Colleyville
Hinge replacement in Colleyville typically runs $220 to $650 per hinge depending on the gate’s weight and whether we need to weld new plates.
How we do it
We support the gate, remove the old hinge, weld in the replacement, and set the gate back to level before photographing the final position.
Custom Welding
Signs you need it
You can see a crack in the iron, a broken picket, or a split at a joint, or the gate flexes when you push it.
What it costs in Colleyville
Custom welding in Colleyville typically runs $180 to $600 per repair point depending on the thickness of the steel and access to the work area.
How we do it
We grind the crack clean, weld it with the correct rod for the metal, and leave the repair in a photo log with the part number of any replacement stock used.
What Gate Parts & Welding Costs in Colleyville
| Item | Typical range in Colleyville |
|---|---|
| Hinge replacement | $220 - $650 per hinge |
| Custom welding repair | $180 - $600 per point |
| Gate roller replacement | $150 - $400 per roller |
Do you weld cast iron or only steel?
Most Colleyville estate gates are ornamental steel, and we weld that with the correct rod for the thickness. Cast iron is rare on these gates, and we’ll tell you honestly if a piece is better replaced than welded.
Will the weld hold on Colleyville clay soil?
The weld will hold. What fails on clay is the post plumb, so we check post movement before welding and tell you if realignment is also needed, with that price included in the written quote.
Brands We Service in Colleyville
We service LiftMaster, DoorKing, Elite, Mighty Mule, and five other major automation brands on Colleyville gates. We stock common boards, remotes, and safety edges locally, so most repairs don’t wait on shipping. See our brands for the full list.
Pricing for Gate Repair in Colleyville, TX
| Service | Typical range in Colleyville |
|---|---|
| Keypad replacement or repair | $180 - $480 |
| Video intercom repair | $400 - $1,200 |
| Phone entry or card reader programming | $150 - $350 |
| Hinge replacement | $220 - $650 per hinge |
| Custom welding repair | $180 - $600 per point |
| Gate roller replacement | $150 - $400 per roller |
Heavy ornamental gates on clay soil push labor up because realignment and post checking add time, and that’s included in the written price before we touch anything.
Neighborhoods We Serve in Colleyville
We run calls across the whole city, from the estate lots near Montclair and Tara Plantation to the gated communities off Cheek-Sparger Road and Pleasant Run Road. Typical response time for a Colleyville call is same day, often within a few hours for access control and gate failures.
- Montclair
- Tara Plantation
- Woodbriar Estates
- Remington Park
- Briarwyck
Service Area - Cities Near Colleyville
Our Colleyville crews also cover the surrounding Tarrant County suburbs. We work in Bedford, TX, Euless, TX, Southlake, TX, and Hurst, TX with the same written-price standard.
Serving Colleyville, TX - Our Local Coverage Area
We’re based in the Colleyville area and know this community well. Use the map below to see our service coverage - if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Colleyville
Same day in most cases. A live person answers the phone 24/7, and we dispatch Colleyville calls from our Dallas-Fort Worth office without routing through voicemail. Gate failures and access control issues get priority because the driveway is blocked.
Most Colleyville HOAs require approval for gate replacement or major modification, but repairs that match the existing gate usually don’t. We can document the work with photos and a written scope if your HOA asks for records.
Yes. Every job gets a written price before any tool comes out, covering the parts, labor, and any realignment needed. The price is what you pay unless you approve a written change order. No surprises on the invoice.
Call (817) 674-6552 for a free estimate on any gate repair or access control job in Colleyville. We answer live, we show up with the parts, and we leave you a written record of everything we touched.
What happens when you call
- 1A real person answersNo phone trees - talk to a local gate repair pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3We come out and measureLicensed & insured, at a time that suits you - the visit and the quote are both free.
- 4You get the price in writingLine-itemed, yours to keep, and nothing starts until you say go.
What Colleyville Customers Say
"Gate had been dragging for a year. They photographed the bent hinge post, explained why the operator kept faulting, and gave me a fixed price to correct both."
- Terrence B."Our gate was hit by a delivery truck. They came out, documented the damage properly for the insurer, and the claim went through without an argument."
- Camille R."The safety loop had never been installed correctly by the previous company. They showed me the reading, fixed it, and did not charge me for the diagnosis."
- Patrick H.